Shape to fit into the desired tray, which has been pre-treated with adhesive.

Mix by kneading together for 30 seconds until no streaks are visible.

Remove equal amounts of Base and Catalyst from the jars using the supplied color coded scoops.

Note: Do not mix putty with latex gloved hands!

Seat the loaded tray into the mouth - allow to remain stable until set.Inject Access Gold low-viscosity or Access Monophase directly into a clean, dry, retracted sulcus preparation, using an Access intra oral needle tip (REF 290017).Access Heavy, Access Monophase or Access Purple may be selected, depending on the application. Express Access Impression Material into a prepared tray, pre-coated with adhesive.Contact with latex gloves, hemostatic agents, hand lotions, eugenol or sulphur compounds may interfere with the setting properties of Access Impression Materials. Allow to air dry for five (5) minutes before using. Note: For faster procedures, it is advisable to use two (2) mixing dispensers.Īlways apply a thin layer of Access Impression Material Tray Adhesive to a clean, dry impression tray. Any of the viscosities will chemically adhere to another viscosity, permitting a wide range of possible techniques.

Special hydrophilic surfactants have been added to Access Impression Materials to allow them to be highly wet table in a moist environment.

The material is odorless and tasteless, and may be soaked in common disinfecting solutions without distortion. Highly accurate and stable, Access impressions may be poured immediately or up to two (2) weeks after the impression is made. 3 Load the tray with impression material and take the impression.ĪCCESS IMPRESSION MATERIALS (VPS - VINYL POLYSILOXANE)Īccess Impression Materials are addition reaction silicones which offer excellent physical and dimensional properties. Instructions for Use: 1 Apply a thin layer of Access ® Tray Adhesive to the tray using the applicator brush. A polyether adhesive must be used for polyether impression materials. NOTE: The adhesive does not always secure sufficient adhesion to trays made of other plastic materials or individual trays made of base plates.

Polyether vinyl impression dental